Factory-direct-hardware Hansgrohe 10458 Axor Starck Manual de usuario

Installation Instructions / WarrantyStarck10458XX1

2Starck 10458XX1Axor Starck Free-standing Tub Filler Rough 10452181This rough is for use with Axor Starck free-standing tub fillers 10458XX1, 10456XX

3Starck 10456XX1Tub shown: HOESCHPhilippe Starck Edition IIFreestanding tub with outside covering.

4Starck 10406001 If clearance is less than 1 1/8“, order extension 97686000.Tub shown: DuravitPhilippe StarckStarck XFreestanding tub with outside c

5Technical DataOperating pressure: max. 145 psiRecommended operating pressure: 14.5 - 72 psiTest pressure: 232 psiHot water temperature: max. 176°

6Installation – 10452181Use the rough as a template to mark the positions of the screw holes in the subfloor. Use an 8 mm bit to drill the holes.Inst

7Replace and tighten the plugs (1). Pressure test the unit (2).Install the plaster shield. Use a 5 mm Allen wrench to tighten the screws.Install the

8Axor Montreux Free-standing Tub Filler Rough 16549181This unit is for use with Axor Montreux free-standing tub filler 16547XX1.

9Technical DataOperating pressure: max. 145 psiRecommended operating pressure: 14.5 - 72 psiTest pressure: 232 psiHot water temperature: max. 176°

10Installation – 16549181Wrap the threads on the two plugs with Teflon thread tape. Install one plug on each rough.Use the mounting plate as a templa

11Remove the flush insert plug from the cold water side of the rough. Install a hose bibb and a hose. Turn on the water and allow the line to flush

2Axor Starck Free-Standing Tub Filler10458XX1Technical SpecificationMaximum water pressure 145 psiRecommended water pressure 14.5 - 72 psiMaximum

12Install the flooring material. Please know and follow all applicable local codes regarding waterproofing. The surface of the finished floor must fa

13Cleaning Recommendation for Hansgrohe ProductsModern faucetry and shower products utilize a combination of materials to comply with the needs of the

14Limited Lifetime Consumer WarrantyThis product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”).

15This warranty gives you specific legal rights, and you may have other rights which vary from State to State.You may be required by law to give us a

Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004Tel. 770 360-9880 • Fax 770 360 9887www.hansgrohe-USA.comUS - Installation Instr

3InstallationTurn off the water at the main.Cut the plaster shield so that it extends 3/8" above the surface of the finished floor.Use an 8 mm Al

4Seal the floor around the plaster shield with waterproof sealant (1). Gently guide the escutcheon to the floor (2). Insert the black rubber washer i

5Replacement Parts1 handle 96928XXX2 color ring 962990003 handle fixing set 941840004 cartridge 941490005 diverter assembly 96294XXX6 aerat

6Cleaning Recommendation for Hansgrohe ProductsModern faucetry and shower products utilize a combination of materials to comply with the needs of the

7THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:A. Conditions, malfunctions or damage not resulting from defects in material or workman

Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004Tel. 770 360-9880 • Fax 770 360 9887www.hansgrohe-USA.comUS - Installation Instr

Starck10452181Montreux16549181Installation Instructions / Warranty