
3
Installation
If installing with Duravit Starck X tub, please see the
instructions starting on page 5.
• Cut the plaster shield on the rough-in 3/8" above the
finished floor.
• Remove the flush block using an 8 mm allen wrench
(not included) to remove the 4 bolts. Do not
discard the bolts!
• Install the tub filler to the rough. Slide the escutcheon
up and out of the way. Make sure that the unit is level
in all planes. Use the 8mm allen wrench to tighten
the bolts evenly.
Comentarios a estos manuales