Factory-direct-hardware Hansgrohe 14314 Talis C Manual de usuario Pagina 7

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 16
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 6
7
Four-Hole Models only
Install the pin on the diverter.
Press the guide bushing rmly into place.
The hole in the pin should be clearly visible
through the slot in the guide bushing.
Lubricate the diverter o-rings using white plumb-
ers grease.
Press the diverter assembly rmly into the spout
tee until it is fully seated.
Firmly press the spout over the diverter.
Tighten the screw using a 3 mm Allen wrench.
Do not overtighten the
screw.
Overtightening the screw
will deform the o-rings,
causing a leak.
Install the diverter rod. The threaded end of the
diverter rod must go into the hole in the pin.
3 mm
Vista de pagina 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comentarios a estos manuales

Sin comentarios