Factory-direct-hardware Hansgrohe 39143 Manual de usuario descargar pdf (Pagina 3)

· Pull the inserts from the plaster

shields on the hot and cold rough-

in valves.

· Trim the plaster shields on the hot,

cold, and spout to 1/16” from the

finished wall.

· Lever handle model only:

Use a 17 mm deep socket wrench

to remove the cartridges from the

rough-in. Install the new ¼ turn

ceramic cartridges included with

the trim kit. The new hot cartridge

is marked with notches on the

wrench flats.

· All models: Install the white

plastic threaded sleeve to the hot

and cold sides of the valve. Use

a ruler to measure a point on the

sleeve 3/8” from the surface of

the finished wall. Mark the sleeve

at that point. Cut the sleeve.

Insert the inner sleeve.

1 2 3 4 5 6 7 8

Sin comentarios

Factory-direct-hardware Hansgrohe 39143 Manual de usuario Pagina 3