Factory-direct-hardware Hansgrohe 38020 Manual de usuario descargar pdf (Pagina 4)

Set the high temperature limit stop (optional)

Remove the screw cover, located on the back of the

handle.

Use a 4 mm allen wrench to loosen the screw.

Remove the handle

Remove the flange and the green high temperature limit

stop ring.

Install the high temperature limit stop ring so that the

black positioning pin is in the notch corresponding to

the desired high temperature.

The temperatures shown in the diagram assume an

incoming cold water temperature of 50°F and an

incoming hot water temperature of 140°.

Center and replace the flange.

Replace the handle.

Tighten the screw.

1 2 3 4 5 6 7 8

Sin comentarios

Factory-direct-hardware Hansgrohe 38020 Manual de usuario Pagina 4