Factory-direct-hardware Hansgrohe 18115001 Manual de usuario descargar pdf (Pagina 4)

Insert a measuring device in the spout outlet. Measure

from the port on the rough to the end of the plaster shield.

Record this measurement (X). Add 2” to X. Cut the spout

connector so that it is X + 2” long.

Wrap the threads on the spout connector with Teflon

thread tape (1). Screw the spout connector into the spout

port using a 12 mm Allen wrench (not included) (2).

The spout connector should extend 1 3/16” outside the

surface of the finished wall.

Install the handle sealing rings, escutcheons, nuts, snap

connectors and screws, and color rings (3). The blue

color ring should be on the right, the red color ring on the

left.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Factory-direct-hardware Hansgrohe 18115001 Manual de usuario Pagina 4