Factory-direct-hardware Hansgrohe 10456 Axor Starck Manual de usuario descargar pdf (Pagina 3)

Installation Instructions

• Turn off the water at the main.

• Cut the plaster shield so that it extends 3/8" above the surface of

the finished floor.

• Use an 8 mm allen wrench (not included) to remove the three

screws from the flush housing. Remove the flush housing. Do not

discard the screws.

• Use the reserved screws to attach the trim to the rough. Pivot the

top of the trim so that the spout faces the correct direction. Use

a level to make sure that the unit is straight.

• Seal the floor around the plaster shield with a waterproof,

1 2 3 4 5 6 7 8

Sin comentarios

Factory-direct-hardware Hansgrohe 10456 Axor Starck Manual de usuario Pagina 3