Factory-direct-hardware Hansgrohe 06120 Swing C Manual de usuario descargar pdf (Pagina 2)

3-Hole Roman Tub Rough

06607000

Technical Specification

Recommended operating pressure 45 - 80 psi

Recommended hot water temp. 120

- 140

Max. flow rate 10 gpm

Hole sizes

valves 1 1/4”

spout 1 3/8”

spout pin 3/16”

Max. mounting surface thickness 1 9/16”

Requires 1/2” supply lines (not included)

*Please know and follow all applicable local plumbing codes when setting the temperature on the

water heater. In Massachusetts, the water heater may be set no higher than 112

Installation Considerations

For best results, this unit should be installed by a licensed, professional plumber.

Large differences in pressure between the hot and cold supplies should be balanced.

The included connecting tubes are type “K” copper tubing. If an installation different from

the one shown here is desired, the plumber may provide his own copper tubing.

To insure proper fit of the trim, this valve should be installed after the mounting surface is

finished and made watertight.

The hot and cold water supplies should be flushed thoroughly before installation of this

rough valve. Damage to the cartridges caused by debris is not covered by the warranty.

1 2 3 4 5 6 7 ... 11 12

Sin comentarios

Factory-direct-hardware Hansgrohe 06120 Swing C Manual de usuario Pagina 2